# Make your own latex fashion

**Make your own**

**fashion latex rubber, latex clothing and lingerie**

**Latex fabrics per meter, tips for making and gluing latex and rubber clothing yourself, repairing latex clothing and lingerie, and upholstering furniture and decor backgrounds etc.**

**Latex fabrics available in our latex per meter shop.**

Latex / rubber clothing and latex / rubber lingerie, latex jewelry or your furniture upholstered with latex, let your imagination run free, crafting with latex is a fun, creative and exciting activity.

For everyone it is very easy to make your own latex / rubber workpieces or latex clothing to repair, bonding latex requires some practice, you must work accurately and neatly for a good result.

First cut the latex to size with good scissors or cut with a rotating knife.

Be considerate of the adhesive edges.

You can obtain and collect clothing patterns everywhere, you can also copy clothing and lingerie, or create your own exciting and interesting latex creation, the possibilities to create fun latex creations are endless.

In this latex shop available thicknesses: latex 0.15mm, 0.25mm, 0.40mm, 0.40mm, 0.50mm, 0.60mm, 0.80mm, 0.80mm, 1mm.

The solid latex with a thickness of 1mm and 0.80mm, is ideal for making latex harnesses, belts, and so on.

The thinner latex for making your own latex clothing and lingerie.

Inset/adhesive zipper: Apply Solvent latex glue well on the fabric of the zipper, and then let it dry, here after the latex glue edges (where the zipper should come) strengthen it by a strip of latex to paste, then apply the zipper on it, and then again an extra strip of latex to be glued on it, (sandwichen).

Always use nickel-free and copper-free zippers, see our shop for plastic zippers.

General instructions: Remove the talcum powder from the edges of the adhesive and roughen the edges lightly with very fine sandpaper (good for a good adhesion of the latex glue).

Then degrease the latex (adhesive edges) well (degreasing latex is very important!), e.g. with isopropanol alcohol or with our special latex degreaser (available in our latex shop).

If you wish, you can attach the latex parts with paper tape (masking tape), also double-sided tape is useful. Then apply a thin layer of Solventlatex glue or water-based latex glue on both parts (when using the solvent glue the latex curls up), for the thicker latex this is less, when the glue dries the latex edge will straighten again (let it dry about 2-5 minutes).

After drying the latex parts firmly press together (a pressure roller works perfectly). Try it first with a piece of latex left over, before you start with the actual piece. A good preparation is half the job.

Is the work piece ready and is the glue dried, then lightly wash in a hand dishwashing detergent such as "Dreft" and treat with VIVISHINE.

We sell 2 types of glue: solvent base and water base.

**About our Solvent latex glue:**This latex glue is superior, but dries quickly when you leave the bottle of latex glue open, (so pay attention), latex glue degreaser to degrease the glue edges, so use degreaser and let dry, before you apply the glue.

Our latex glue is water resistant, with very good adhesive properties,

**About our water-based latex glue:**you can easily glue the thin latex, the latex does not curl up with this glue.

Always degrease the latex well in advance (but longer drying time with this adhesive desired.

Also take a look in the latex glue and tool shop for various haberdashery that can be useful when making your latex workpiece.